Programming a Genie Garage Door Opener Remote – Intellicode
The following instructions are for programming a Genie garage door opener intellicode remote. If you have an older model Genie opener you may need to follow a slightly different procedure. These instructions should also allow you to clear all the programming codes from your opener. Clearing the codes from the opener’s receiver is the only way to disable a lost remote.
Make sure to keep everyone, including pets, out of the path of the garage door when programming a remote or keypad.
- Locate the “learn” button on the opener. The location of the learn button is dependant upon the model opener. It can typically be found under the light cover. The learn button will have a small indicator light next to it.
- Press and release the learn button
- Press and release the button on the remote.
- Press and release the button on the remote once again.
That’s it. The remote should be able to operate the opener at this point. Repeat these steps for any additional remotes or buttons you may wish to program.
To clear all existing codes from the receiver:
- Press and hold the learn button on the opener for 10 seconds, or until the indicator light goes out.
Clearing the codes will erase all programming from the receiver. This feature is useful if a remote has been lost, or if you wish to disable any old remotes or keypads. After clearing the codes, remotes or keypads will need reprogramming.